2. Elastomer performance
In this section, some specific properties of elastomers are presented to facilitate the selection of a compound for a given use.
The service temperature limit of a rubber article cannot be separated from the conditions of use. The length of time at temperature, the application cycle (continuous or discontinuous), the environment (air, water, oils, ozone, etc.) and the type of stress (static or dynamic) all influence the final behavior of the product.
Under normal aerobic conditions, degradation begins at a temperature linked to the chemical structure of the elastomer, but this can be modified by the addition of oxygen, ozone and heat protection agents specific to each type of compound.
Table 4 summarizes the heat...
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!
Ongoing reading
Elastomer performance
Economic data
Production capacity and consumption
Although some production figures are estimated, the world total of 6.4 million tonnes of natural rubber corresponds fairly closely to reality in 1996.
...
Bibliography
References
-
(1) - SIS Handbook. - Distribué par LRCCP (1981).
-
(2) - PRUETT (M) - Chemical resistance. Guide for elastomers. - Compass Publications (1988).
-
(3) - FERRY (J.D.) - Viscoelastic properties of polymers. - 3e édition, chap....
Standardization
The standards for the main tests cited in article K 380 are listed in table 3.
Suppliers
The main suppliers are listed in tables 4 and 5.
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!