5. Active closed-loop control
5.1 Analog systems
When a reference signal strongly correlated with the noise to be reduced is not available to drive the control system, the error signal can be used, after processing by the controller, to drive the secondary source: this is known as active closed-loop control (figure 5 c ).
...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Active closed-loop control
Appendix: signals and systems
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Noise and vibration"
(
87 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
