5. Process modeling and control
5.1 Confrontation with experience
The models provide a good approximation of reality. The force exerted on the last cylinder was measured on an instrumented laboratory calender over a wide range of rotational speeds and air gaps. Figure 37 compares the measured forces with the calculated forces.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Process modeling and control
Extrusion – calendering
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
356 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
