7. Part extraction
The evacuation system is used to remove the article from the mold (figure 5, 6). The evacuation clamps are installed before the mold is opened (figure 5, 5). They are temperature-controlled to prevent the material from sticking.
After removal from the mold, the part can be decarotized either manually, by robot, or through a mask that follows the part's geometry. After separation of the blow-molded...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Part extraction
Aftercooling
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
355 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
