5. Results and sensitivity analysis
The aim of this section is to show the results that can be obtained with injection molding software, and to analyze the sensitivity of the result to variations in the data. The results obtained are applicable to the material chosen in this section and may differ for other polymers. However, trends will be respected.
5.1 Calculation data
We will take the center-injected disk of 150 mm radius, with an initial radius of 5 mm. Although a 1.5D calculation of the type described in section 2
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Results and sensitivity analysis
Conclusion
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
356 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
