3. Two-dimensional thin-film approach
We now turn our attention to the flat die coextrusion process with coextrusion box (figure 5 ). In this case, the challenge is to adjust the position and geometry of the lamellae in the coextrusion box (zone D in figure 5 ), as well as the flow rate of each polymer, to ensure uniformity of the overall thickness of the manufactured sheet or plate, and that of each of its constituent layers, at the die exit. The problems of instability at interfaces mentioned...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Two-dimensional thin-film approach
Conclusion
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
356 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
