3. Tolerance values
3.1 Modulus classes for reference diameter and tooth width
The upper and lower scaling limits (of reference diameter d, modulus (actual modulus) m n and tooth width b ) for tabulating from the formulas are given in Table 3 .
3.2 Choice of module, reference diameter and width to determine permissible deviation
In applying the formulas, the parameters m n ...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Tolerance values
Bibliography
- HENRIOT (G.) - Engrenages. Conception, fabrication, mise en œuvre. - 1999 Dunod - Engrenages : définition, éléments pour la fabrication, contrôle, tables d'involutes. CETIM (Centre technique des industries mécaniques) ouvrage collectif (1998).
Standardization
French and European...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Mechanical and dimensional measurements"
(
126 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
