1. Cutting cylindrical gears without generation
1.1 Form milling
Figure 1 shows a modular milling cutter. It is a milling disk with a constant profile in all grinding planes passing through the axis.
These modular hobs are standardized (see table 1). The same cutter covers a given number of gear teeth. The profiles of these teeth are replaced by a number of circular arcs. Figure 2,...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Cutting cylindrical gears without generation
Generation trimming
References
- (1) - HENRIOT (G.) - Traité théorique et pratique des engrenages – Tome II – Fabrication contrôle Lubrification – traitement thermique – ensemble à engrenages. - Bordas – Dunod (1983).
- (2) - BELLAIS (Cl.) - Outils coupants. Taillage des roues cylindriques. - , Travail des matériaux. Assemblage (1995). ...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Material processing - Assembly"
(
178 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
