2. Modification of geometry and change of process
2.1 Methodology
When designing a part, or in this case redesigning one, the first questions that come to mind are: where to start? And how to proceed?
To address this, a methodology is proposed.
Key points to remember
1. Define interfaces and functional areas.
2. Define a design volume.
3. Define a design objective (minimum mass, maximum stiffness, cost, etc.) and design constraints (safety factor, etc.).
4. Perform topological optimization.
5. Define a manufacturing direction.
6. Define the manufacturing range (raw material from FA, machining, heat treatments, surface finishing, etc.).
7. Create the digital model, incorporating...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Modification of geometry and change of process
Part manufacturing
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Additive manufacturing -3D printing"
(
58 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
