Piping - Control and tolerance of support : Interpretation of results

Interpretation of results
Piping - Control and tolerance of support

Author : Bernard PITROU

Publication date: February 10, 1992 | Lire en français

Add to my library

4. Interpretation of results

See table 3 and figure 5.

These are the easiest to interpret:

check tightening: if it is defective, it must be corrected;
check tie-rod angulation: if the angle exceeds the permissible values, it is necessary to correct or analyze the restoring forces and/or the risk of overstress;
Checks on the elastic supports: they must be neither tightly wound nor completely slack;
stop checks: clearances must remain within tolerances (figure

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed? Log in!

Ongoing reading
Interpretation of results

(1) - CODETI - Annexe supportage. - Publié dans la revue SNCT, fév. 1990.
(2) - LECONTE (J.) (†), PITROU (B.), CHEVALIER (G.) - Chaudronnerie et tuyauteries industrielles. - Tome 2. Éléments d'étude et fabrication. Éd. Techn. et Doc., oct. 1989.

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed? Log in!

Article included in this offer

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources