2. Element characterization
Timing belt drives are naturally subject to standardization. . Not all characterizations are codified, however, and depend very much on the type of subsequent use.
2.1 Belt geometry and mass
The length of the belt, and consequently the pitch p b , can be obtained in various ways, the simplest being to unwind the belt without any longitudinal tension and measure the length directly over a sufficient number of pitches, using suitable means to ensure accuracy. The standardized method (NF ISO 9010) recommends measuring the centre-to-centre distance obtained with a belt mounted on two master pulleys applying low tension, and deducing the length on the assumption that the free strands are straight-line...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Element characterization
Conclusion
Article included in this offer
"Mechanical functions and components"
(
219 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
