5. Cutting methods
5.1 Automatic cutting with thumbwheel
5.1.1 Cutting monolithic glass
This is the most widely used cutting method. It is used for soda-lime silicate glass in thicknesses from 2 to 19 mm.
Until 1950, the operator, known as the "cutter", worked on a fixed table covered with a felt mat. He scribed with a diamond wheel mounted on a hand-held tool holder, while manual breaking was carried out with a ruler.
In the 1960s, the fixed table became a tilting table, equipped with...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Cutting methods
Conclusion
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Glasses and ceramics"
(
68 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
