6. Effect of advanced control systems on internal stress levels
As expected, given the longer effective holding pressure time, the polymer pressure control mode (BFP) generates a higher level of internal stress than the conventional hydraulic pressure control mode. This is evidenced by a reduction in resilience after molding (2 days after injection) (figure 10 ). Nevertheless, this degradation in impact performance remains limited (-15%) and is not modified by the use of the model.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Effect of advanced control systems on internal stress levels
Conclusion
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
356 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
