3. Troubleshooting
The aim of this section is to review the main practical problems encountered in extrusion, and to give a few simple recipes for solving them.
3.1 Problems mainly due to the extruder
Product temperature is considered too high when :
the product smokes or decomposes;
the product deforms after reception (viscosity too low to hold);
the product no longer has good mechanical properties.
The reasons may be related to process...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Troubleshooting
References
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
355 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
