6. Choice of control fluid
Once the control channels have been designed, the choice of fluid and its flow rate determine the quality of cooling.
6.1 Thermal performance of control fluids
The efficiency of heat exchange in a tool depends directly on the choice of fluid. and thermal properties, as shown in table 5. The control fluids most commonly used to cool plastic part forming tools are water and oil....
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Choice of control fluid
Thermal metrology in an injection mold: flow sensors
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Plastics and composites"
(
355 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
