4. Error settings
There are four types of errors: directivity errors, mismatch errors, frequency response errors, and isolation errors.
Directivity errors are caused by the fact that, when using couplers (or bridges) in a reflection setup, unwanted directivity signals are superimposed on the signal reflected by the device under test, thereby causing measurement errors in reflection. The more directional the coupler, the lower the directivity errors. The main cause is non-infinite directivity, defined by the ratio between the isolated (loaded) channel and the coupled channel of the coupler (or bridge) used.
Mismatch errors cover all the different impedance mismatches relative to the reference impedance (mismatch of the generator, couplers, or bridges, as well as the harmonic...
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!
Ongoing reading
Error settings
Bibliography
-
(1) - BAREAU (P.) - Analyseurs de réseaux en micro-ondes - . Techniques de l'Ingénieur R 1 145, 4-1991 Archives.
-
(2) - ENGEN (G.F.) - Microwave circuit theory and foundations of microwave metrology - . IEE Electrical Measurement, series 9 (1992).
-
(3)...
Manufacturers
(non-exhaustive list)
Network analyzers
AGILENT TECHNOLOGIES (Scalar [10 kHz-110 GHz] and Vector [10 Hz-325 GHz])
ANRITSU (Scalar [10 MHz–110 GHz] and Vector [10 Hz–325 GHz])
ROHDE & SCHWARZ (Vector [300 kHz-40 GHz])
Accessories
Agilent Technologies (Calibration and verification kits, adapters, cables, coaxial components [DC to 110 GHz] and waveguide components [8.2 to 110 GHz])
...
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!