Cooling
Extrusion lines in the cable industry. - Manufacturing steps

Article REF: AM3641 V2

Cooling
Extrusion lines in the cable industry. - Manufacturing steps

Authors : Stéphan PUISSANT, Alexandre FEUILLET

Publication date: April 10, 2026 | Lire en français

You do not have access to this resource.

Request your free trial access! Free trial

Already subscribed?Log in!

5. Cooling

After being applied to the conductor, the insulation or sheathing material must be cooled so that the cable can be wound. This cooling is achieved by passing the wire (or cable) through cooling tanks (Figure 24 ).

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed? Log in!

Ongoing reading
Cooling

Previous
page Different types of heads and dies

Line speed and drive

Article included in this offer

"Plastics and composites"

( 349 articles )

Complete knowledge base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

View offer details

Bibliography

(1) - AGASSANT (J.F.), AVENAS (P.), SERGENT (J.-P.), VERGNES (B.), VINCENT (M.) - La mise en forme des matières plastiques. - 4e édition. Lavoisier Technique & Documentation (2014).
(2) - RAUWENDAHL (C.) - Polymer extrusion. - 3e édition....

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed? Log in!

Outline
Full outline