2. Chip removal machining
2.1 Shearing, punching
Cutting and punching plastic sheets up to approx. 3.0 mm thick is often possible at room temperature or by heating to approx. 50 ×C.
The cutting tool must be particularly sharp and undamaged. There must be a maximum clearance of less than 1 mm between the moving cutting part and the fixed part. The cutting angle must be less than 70×.
SCROLL TO TOP2.2 Sawing
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Chip removal machining
Parameters by polymer family
Article included in this offer
"Plastics and composites"
(
329 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
