6. Surface finishing of sheet metal structures
6.1 Degreasing
This operation is designed to avoid the risk of surface recarburization on parts that are to be heated (welding zones, parts prior to hot forming or heat treatment). Chlorine-free solvents must be used.
SCROLL TO TOP6.2 Surface repairs
Scratches or indentations formed during welding operations are acceptable only if they are not folded (recessed) or sharp-edged. Polishing with a belt or grinding wheel (minimum 120 grit) is normally sufficient to eliminate them.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Surface finishing of sheet metal structures
Corrosion resistance of boilers
Article included in this offer
"Hydraulic, aerodynamic and thermal machines"
(
177 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Basic works
Reference
In Engineering Techniques
On stainless steels
On forming
About welding
Basic works
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
