1. Objective
The reason we place so much emphasis on modeling is that the aim of CAD is to create a model (virtual mock-up) with the following two properties:
represent object properties (in the broadest sense) ;
be usable (calculations, simulations, preparation of ranges, etc.).
it is of course essential to have the necessary hardware (computer, screen, etc.), which we won't go into here as their characteristics are well known.
The general architecture of a CAD system is shown in figure 1 .
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Objective
Modeling
Article included in this offer
"Additive manufacturing -3D printing"
(
56 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
![Écoutez notre podcast Cogitons Sciences : Clément Thivin, un ingénieur pas bateau [Des ingénieurs qui cassent la routine #3]](https://www.techniques-ingenieur.fr/actualite/wp-content/uploads/2022/04/visuel-Article-actu-Podcast-12-ok-2.png)
