1. Control gasometers

1.1 Description

The gasometer is used to calibrate and check gas meters with a maximum flow rate of less than 1,600 m ³ /h. It is only used for calibration in air, at low pressure.

SCROLL TO TOP

1.1.1 General provisions

The gasometer (figure 1 ) essentially consists of a bell dipped more or less into the liquid in a tank.

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed? Log in!

Ongoing reading
Control gasometers

Previous
page Calibration and periodical verification of gas flowmeters

Checking meters at atmospheric pressure and in dry air

Article included in this offer

"Physical measurements"

( 67 articles )

Complete knowledge base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

View offer details

Bibliography

(1) - CASTILLON (P.) - Mise au point d'un étalon de débit constitué de tuyères en régime sonique. - Association technique de l'industrie du gaz en France ATG Congrès (1970).
(2) - MOREAU (G.), HUSSE (R.), GAUCHER (R.), VALLET (J.-P.), KERVEVAN (P.) -...

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed? Log in!