3. Detector installation
To get the best performance from detectors for a given application, you need to use the right radiation observation method, polarization, matching and amplification circuits, and instruments (ammeter, oscilloscope, etc.).
3.1 DC measurements
Where the signal level is high (e.g. electrical signal power in excess of 10 -15 W), and for laboratory work of short duration, simple observation methods can generally be used, based on the basic equipment found in most physics laboratories: galvanometers, electronic voltmeters, resistor boxes, oscilloscopes, etc.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Detector installation
Application examples
Article included in this offer
"Mechanical and dimensional measurements"
(
121 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
