3. Examples of Thickness Verification
As previously indicated, the verification procedure involves calculating
the minimum thickness e1 of a hypothetical single-pane,
monolithic, annealed glass for the loads applied to the actual glazing,
and then verifying that the pre-selected composition satisfies the
comparison equation between eR and e1, as well
as the deformation equation.
Suppose that the loads on a 0.9 × 1.5 m glazing unit, intended
for a frame whose top rail is less than 6 m above the ground (c =
0.9), supported on three sides with a long free edge, are P = 1,200
Pa. These loads result in a value of e1 = 6.97 mm and a
value of ec = 6.97 × 0.9 = 6.27 mm.
-
Strength Verification
Selecting...
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!
Ongoing reading
Examples of Thickness Verification
Bibliography
-
(1) - NF EN 1991-1-4 - - Eurocode 1 – Actions sur les structures
– Partie 1-4 : actions générales – Actions du vent.
-
(2) - NF EN 1991-1-4/NA - - Eurocode 1 – Actions sur les structures
– Partie 1-4 : Actions générales – Actions du vent/Annexe Nationale.
-
(3)...
Also in our database
-
AUBERT (J.) - Vitrages extérieurs collés (VEC) et attachés (VEA). Détermination
des épaisseurs. -
Standards and norms
- Eurocode
1 – Structural Loads – Part 1-4: General Loads – Wind Loads - NF EN 1991-1-4 -
- Eurocode 1 – Actions on Structures – Part 1-4: General Actions –
Wind Loads/National Annex - NF EN 1991-1-4/NA -
- Eurocode
1 – Actions on Structures – Part 1-3: General Actions – Snow Loads - NF EN 1991-1-3 -
- Eurocode 1 – Actions on Structures – Part 1-3: General Actions –
Snow Loads/National Annex - NF EN 1991-1-3/NA...
Directory
Organizations – Federations – Associations (non-exhaustive list)
AFNOR
https://www.afnor.org/acheter-une-norme/
FFPV
https://www.ffpv.org/
Laboratories – Engineering firms – Schools – Research centers
(non-exhaustive list)
...
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!