Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the article
The safety provisions relating to risks arising in the processing of plastics by extrusion and injection have already been dealt with in two other articles of this Treaty:
The aim of this new article is to assess risks and set out measures to control them in other processing techniques:
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!
Ongoing reading
Safety in plastics processing
References
References
-
(1) - Sécurité des machines et des équipements de travail. Moyen de protection contre les risques mécaniques. - Publication INRS (Institut National de Recherche et de Sécurité), ED 807 (2000).
-
(2) - Conception des automatismes pneumatiques. - Publication INRS (Institut National...
Also in our database
-
AUBER (R.), ATLANI (C.) - Prévention des accidents électriques. - [D 5 100] Traité Sécurité et gestion des risques (1996).
-
BERBAIN (F.), CHEVALIER (A.) - Mise en œuvre des composites – Méthodes et matériels. -
Regulations
EEC Directives
Directive 2006/42/EC on the approximation of the laws of the Member States relating to machinery. Adopted in April 2006. Published in June 2006 in the EU Official Journal. It must be transposed by each state into its own law by June 29, 2008 at the latest. Its application date has been set at December 29, 2009. Until then, Directive 98/37/EC remains valid.
Annex 1: Essential health and safety requirements...
Standards and norms
Association française de normalisation AFNOR
Directory
Organizations – Federations – Associations (non-exhaustive list)
AFICEP (French Association of Rubber and Polymer Engineers and Managers) http://www.aficep.com
AFNOR (Association Française de Normalisation) www.afnor.fr
ASTM International
You do not have access to this resource.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed?
Log in!