5. Membranes and bulkheads bonded to the hull
The hull is contact-molded beforehand, then the frames and reinforcements are added.
It is very important to distribute the stresses over as large an area as possible, with local reinforcements, laminations and layering of graded laminated layers, and suitable design, as shown in figure 7 . Laminating enables L-shaped reinforcements to be produced, resulting in a good T-joint (figure 7 ).
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Membranes and bulkheads bonded to the hull
Deck to hull assembly
Bibliographical reference
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Material processing - Assembly"
(
178 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
