Influence of manufacturing process on hole exit delamination
Delamination analysis during long-fiber composite drilling
Research and innovation REF: RE228 V1
Influence of manufacturing process on hole exit delamination
Delamination analysis during long-fiber composite drilling

Authors : Redouane ZITOUNE, Francis COLLOMBET

Publication date: November 10, 2013 | Lire en français

Logo Techniques de l'Ingenieur You do not have access to this resource.
Request your free trial access! Free trial

Already subscribed?

2. Influence of manufacturing process on hole exit delamination

2.1 Experimental protocol

The composite material studied is HexFIT ® (Hexcel Film Infusion Technology). It is a 2 × 2 glass/epoxy semi-preg woven twill composite with a ply thickness of around 1 mm, manufactured by Hexcel Composite. It is processed using the resin film infusion principle. In terms of cost, it is a good candidate for the manufacture of large composite panels

You do not have access to this resource.
Logo Techniques de l'Ingenieur

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource. Click here to request your free trial access!

Already subscribed?

Ongoing reading
Influence of manufacturing process on hole exit delamination

Article included in this offer

"Plastics and composites"

( 329 articles )

Complete knowledge base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

View offer details
Contact us
Contact our team FAQ