3. Grille adjustments and controls
The aim is to obtain a sheet with a regular and constant thickness profile.
-
Calendering parameters
The flow of material between the rolls exerts a linear load along the generatrices and a resistive torque due to the splitting of the material at the roll surface. We'll see in 4 that this flow force depends on roll radius R, sheet width W, calendering speed U, calender roll gap 2 h ...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Grille adjustments and controls
Process modeling
Article included in this offer
"Plastics and composites"
(
356 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
