3. Grille settings and controls
The aim is to obtain a sheet with a regular and consistent thickness profile and uniform tension, enabling a cylindrical coil with a consistent diameter across its entire width to be produced during winding.
3.1 Calendering parameters
The passage of material between the cylinders exerts a linear load on them, distributed over the width l of the sheet at the gap between two successive cylinders (figure 14 ), and a resistive torque due to the shear stress exerted by the material on the surface of the cylinders. We will see in section
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Grille settings and controls
Process modeling
Article included in this offer
"Plastics and composites"
(
327 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
