2. Examples of parts produced and problems encountered
The parts presented here were produced using the partial filling process. All these parts could have been produced using the inertia block process, but the aim is to give processors the best possible advice so that they can produce their parts at the lowest cost and to the highest quality.
As there is no such thing as exclusivity, only a few representative examples have been illustrated, although parts have been produced in the following areas.
Packaging
boxes
pallets
Sports
snowshoes
field hockey sticks
ski bindings
ski boots
Medical field...
The Ultimate Scientific and Technical Reference
This article is included in
Plastics and composites
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Examples of parts produced and problems encountered
Hardware and peripherals
Bibliography
Patents
It wasn't until 2010 that the legal situation reached an epilogue: the legal wrangling that had disrupted the development of the gas-assisted injection process came to an end the day the feeder patent fell into the public domain. But the damage had been done, and many processors had become discouraged by the difficulties.
The Ultimate Scientific and Technical Reference
