Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Jean‐Marie BRIARD : Engineer from the Conservatoire national des arts et métiers (CNAM) - Head of the Raw Parts Department, RENAULT SA Powertrain Division
INTRODUCTION
Parts that have been separated from their feed system will be reworked either before or after shot-blasting, to remove any appendages or protrusions of material. Depending on the cross-section or thickness of material to be removed, and the type of alloy considered, different technologies will be used. The finished part then undergoes a certain number of checks (articles and "Foundry inspection") to check its conformity with customer specifications.
Finally, parts that have been declared good will be packaged before shipment.
The complete study of the subject includes the articles :
— - Foundry completion. Pickling. Shot blasting;
— - Foundry completion. Deburring. Finishing.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Foundry castings finishing - Defining and final finishing
De-rubbing. Degripping
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Article included in this offer
"Metal forming and foundry"
(
126 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
