6. Defects observed during installation. Solutions
As we've seen, the gas-assisted injection molding process has many advantages, but also disadvantages which can have dramatic consequences for the part and therefore for the processor. Indeed, committing to produce a part using this process, and then having to offer the customer an alternative solution because technical problems have not been solved, can be commercially penalizing for the future.
A non-exhaustive list of faults that can be observed when using this process, with a suggested solution or remedy, is given in this paragraph.
-
Material front perforation
Material front perforation is caused by insufficient material injection. To remedy this, simply increase the quantity of polymer injected until a stable process is achieved. In the set-up phase, it is preferable to start by eliminating...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Defects observed during installation. Solutions
Conclusion
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
