2. Examples of parts produced and problems encountered
The parts presented here were produced using the partial filling process. All these parts could have been produced using the inertia block process, but the aim is to give processors the best possible advice so that they can produce their parts at the lowest cost and to the highest quality.
As there is no such thing as exclusivity, only a few representative examples have been illustrated, although parts have been produced in the following areas.
Packaging
boxes
pallets
Sports
snowshoes
field hockey sticks
ski bindings
ski boots
Medical field...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Examples of parts produced and problems encountered
Hardware and peripherals
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
