4. Properties
The general properties of the various styrenic polymers are listed in table 3 (see the section on Standardized testing of plastics in this treatise).
4.1 Mechanical properties
Tensile and flexural properties
Figure 3 shows the tensile stress-strain curves for a standard PS, an impact PS and an SB copolymer. Standard PS behaves like a very rigid but brittle polymer; the other two have a yield point. Tensile stress measurements are carried out in accordance with NF T 51-034 or ISO R 527 standards (see...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Properties
Implementation
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
