2. Thermomechanical modeling
Thermomechanical approaches to chip formation have emerged more recently than previous approaches, as their complexity requires the use of computer calculations. They take into account more of the physical phenomena involved in cutting than earlier approaches, such as heating and high deformation speeds. Based on experimental observations, they still fall within the scope of simplified models, as they involve few unknowns, unlike a method using finite element or finite difference discretization, for example 3
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Thermomechanical modeling
Introduction to numerical cutting simulation
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
- (1) - MERCHANT (M.E.) - Mechanics of the metal cutting process. I. Orthogonal cutting and a type 2 chip (Mécanique de l'usinage des métaux. I. Coupe orthogonale et copeau de type 2). - Journal of Applied Physics (USA), 16, p. 267-275, 2 tabl., 10 fig., bibl. (8) réf., American Institute of Physics New York (1945).
- ...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
