3. Design parameters
3.1 Layout elements
When inserted and soldered components, e.g. wave soldered, are to be installed on a printed circuit board, the minimum hole grid generally adopted is 2.54 mm, which corresponds exactly to 0.1 in. In fact, the pitch of the output pins on components of this type is only 2.54 mm.
With the widespread use of surface-mounted components, the drilling grid can be significantly reduced. However, we strongly recommend the 1.27 mm grid (exact conversion of 0.05...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Design parameters
Materials and manufacturing processes. Associated controls
Article included in this offer
"Electronics"
(
263 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
