6. Mechanical characteristics
These are the characteristics that allow us to measure the mechanical strength of the bonds.
They are generally measured on bonded assemblies after the adhesive has fully cured.
6.1 Mechanical strength. Adhesion and cohesion
To measure the mechanical strength of an adhesive or bonded assembly, two test specimens are glued together, the adhesive joint is allowed to cure completely, and then a separation test is carried out in various modes.
Bonded joints can be stressed in five different ways: tensile, shear, peel, cleavage or creep, as shown in figure 19 . Pure tension and cleavage, which concentrate...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Mechanical characteristics
Physico-chemical characteristics and durability
Article included in this offer
"Wood and paper"
(
55 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
