2. Make an inventory of all the information required for welding
Take a look at all the aspects, without forgetting one factor. Hot-air welding is so simple that anyone can make a good weld. Getting the weld right - aesthetically, mechanically, etc. - may be different.
It's also important to be able to anticipate potential failures or difficulties ahead.
2.1 List the functions of your assembly
You can use functional analysis to identify all the functions of the weld (see Functional analysis: methods for identifying functions
The Ultimate Scientific and Technical Reference
This article is included in
Design and engineering management
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Make an inventory of all the information required for welding
Research equipment or design a heater for welding applications
Bibliography
Also in our database
Regulatory references
NF EN 13067 : December 2012 — Plastics welding personnel — Welder qualification test — Thermoplastic welded assemblies
AFG B.527.9 : According to the specifications of the French Gas Association, qualification test for polyethylene operators.
Products and suppliers
Training and Consulting
AFPMA: Practical training in metal and plastic sheet metal work — DMOS - QMOS - QS according to NF EN 13067 and ATG B.527.9
Contact Mr MONIN Bernard on 04 74 32 36 47 or [email protected]
4 Development centers: Training and advice on materials assembly — DMOS - QMOS - QS according...
The Ultimate Scientific and Technical Reference
