Overview
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHORS
-
Christian BONZOM : Associate Professor of Mechanics IUFM
-
Éric FARGIER : Head of Metrology Unit LNE Sud (Laboratoire national de métrologie et d'essais)
INTRODUCTION
In addition to the requirements covered in Part 2, there are modifiers that transform the interpretation of the specifications to which they apply.
This section deals with :
the envelope requirement;
the notion of projected tolerance ;
the maximum material principle.
This section also highlights :
constraints on the orientation or position of tolerance zones for the various defects addressed;
the impact of measurement on product definition.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Errors of shape, position, orientation, beat. Part 3
Tolerance zone position
Article included in this offer
"Mechanical and dimensional measurements"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Works
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
