2. Geometry and operating mode
As previously mentioned, the co-mixer, like the twin-screw extruders, has a modular structure, made up of elements placed one after the other on a splined shaft. The sheaths are lined and made up of two half-shells. They can be easily opened to gain access to the screw and change the liners. The liners are perforated to enable them to be fixed to the sleeve (via "flat" mixing fingers) and to allow installation of the mixing fingers that will promote mixing. They can easily be replaced when they become worn, or when you wish to add or remove a restriction ring (see § 2.1.3 ).
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Geometry and operating mode
Influence of operating parameters
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
