2. Measurement methods
All RTD measurements are based on the detection, via its concentration, of a tracer introduced at the entry of the process. This introduction can take the form of a Dirac pulse (instantaneous) (figure 3 a) or a step change (figure 3 b). Tracer concentration is measured at the output and the RTD functions are calculated according to:
The Ultimate Scientific and Technical Reference
This article is included in
Plastics and composites
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Measurement methods
Experimental results
Bibliography
Software tools
The Ludovic© software described in paragraph 4.4 is marketed by SCC:
Sciences & Computers Consultants
46 rue de la télématique, 42000 Saint-Étienne, France
The Ultimate Scientific and Technical Reference
