4. Extrusion instabilities and defects
Let's start by defining a stable bubble. According to Laffargue , a bubble can be considered stable when the amplitude of geometric variations (radius, freezing position, etc.) remains below 5%. Figure 19
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Extrusion instabilities and defects
Modeling
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
- (1) - - Reinfenhauser http://www.reifenhauser. com/en/folienanlagen/p0003_schlauch_mod.asp
- (2) - - Plastics Extrusion...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
