4. Implementation
4.1 Molding cycle
The standard molding cycle for a part processed by the RIM process can be described as follows:
PRESS OPENING;
demoulding of the previous part after movement of the moving parts of the tooling, if necessary;
brief cleaning of the mould to remove any burrs from the parting lines;
application of external release agent where non-self-releasing materials are used;
moving the mould's moving parts so that the mould can be closed;
closing the press after tilting the platens to the horizontal position ;
rapid recirculation of...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Implementation
Interest
Article included in this offer
"Plastics and composites"
(
347 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
References
- (1) - TOUHSAENT (R.E.), THOMAS (D.A.), SPEILING (L.H.) - J. Polymer Science, 46, p. 175 (1974).
- (2) - KLEMPNER (D.) - Angew. Chem. Int. Ed. Enge, 17, p. 97-106 (1978).
Works
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
