Overview
ABSTRACT
The drilling of long-fiber composite materials often entails three types of damage listed according to their area of occurrence: delamination at the entrance of the hole, resin and fiber degradation in the wall of the hole and delamination at the exit of the hole. The analysis of exit delamination allows for predicting the factor responsible for this damage i.e. the thrust force. The discrepancies observed between the results given by the numerical model, the analytical model and the experimentation are analyzed.
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Dr. Redouane ZITOUNE: Associate Professor-HdR at IUT-A, Université Paul Sabatier
INTRODUCTION
Field: modeling the drilling of composite materials
Degree of technology diffusion: Emergence I Growth I Maturity
Applications: aeronautics, transport, automotive, electronics, civil engineering
Main French players :
Competence centers: Institut Clément Ader, Toulouse
Manufacturers : Latécoère
Contact: http://www.institut-clement-ader.org/pageperso.php?id=rzitoune
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
KEYWORDS
modelling | | automobile | transport | aeronautics | Drilling | machining | composites | delamination
CAN BE ALSO FOUND IN:
Delamination during drilling of a carbon-epoxy composite
Delamination by drilling
Article included in this offer
"Material processing - Assembly"
(
161 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
