2. Movements and trajectories
2.1 Cutting movements
The penetration of a tool into a workpiece is only possible if it is moved with sufficient energy. This cutting motion can be assigned to the tool, which is the most frequent case (sawing, milling, drilling, etc.), but sometimes also to the workpiece (turning, peeling, slicing, etc.).
This cutting movement can be :
straight: hand tools, band saw, reciprocating saw ;
circular: the movement of almost all woodworking tools;
complex: the case of certain mortise and tenon chisels.
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Movements and trajectories
Chip
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
