6. Tool wear
From the very first press stroke, the tool changes. It acclimatizes at the very start of production (running-in phase), then generally evolves slowly over the course of production until a certain limit is reached, at which point wear accelerates (figure 52 ). Wear can be more or less rapid, depending on the type of degradation encountered. The characteristics of the cut part will then be influenced by this wear, and cutting forces will also change (see § 3.1.2
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Tool wear
Conclusion
Article included in this offer
"Material processing - Assembly"
(
174 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Also in our database
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
