4. Printability of 3D printing materials
The use of resins in SLA has been extensively discussed, particularly with regard to liquid resins that may contain fillers of various origins. This section will focus on conventional materials based on their forms, in conjunction with the main additive manufacturing technologies. These are essentially “materials by design,” meaning that the material is not a raw material to be worked with, but rather the product of a design.
4.1 Thermoplastic filaments and extrusion
In 1988, Scott and Crump founded Stratasys to commercialize the FDM (Fused Deposition Modeling) process, which was patented the following year. 3D printing using a heated filament that is melted as it is deposited (FDM/FFF) is a simple-in-principle (yet disruptive) additive manufacturing technology;...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Printability of 3D printing materials
Conclusion
Article included in this offer
"Additive manufacturing -3D printing"
(
56 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
- (1) - TIAN (X.), TODOROKI (A.), LIU (T.), WU (L.), HOU (Z.), UEDA (M.), HIRANO (Y.), MATSUZAKI (R.), MIZUKAMI (K.), IIZUKA (K.), MALAKHOV (A.V.), POLILOV (A.N.), LI (D.), LU (B.) - 3D Printing of Continuous Fiber Reinforced Polymer Composites : Development, Application, and Prospective. - Chinese Journal...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
