2. Slopes
The minimum slopes and minimum coverages for flat tiles are shown in the table 1 , according to the "application zones" and "situations" defined in paragraph 6 of the fascicule. .
The minimum slope is that of the roof, not that of the individual tile. The table 1 applies to slopes whose horizontal projection length does not exceed 8 m.
Remarks
• Rampants with a horizontal projection of more than 8 m require special provisions to ensure watertightness at the bottom of the slope. These special provisions, specific to each building site, are not covered in the present...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Slopes
Supports
Article included in this offer
"The finishing and equipment of the building"
(
90 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
