4. Installation, assembly and maintenance
The provisions of the European standards on installation and, above all, assembly have changed radically in relation to the French standard NF P 25-362. This change is essentially induced by the application of the "Construction Products" directive, and by the fact that the standard specifies that "an installer who assembles components from different suppliers is considered to be the manufacturer" within the meaning of the European standard. Thus, an assembler, considered as a manufacturer, must meet all the requirements of the latter, particularly with regard to CE marking.
It is possible to differentiate between the following three most common cases:
installation of a complete product, i.e. from a single supplier and without any modification to the product;
assembly of components...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Installation, assembly and maintenance
Planned developments
Article included in this offer
"The finishing and equipment of the building"
(
90 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Standardization
Association française de normalisation AFNOR
- Doors for industrial, commercial and garage premises – Resistance to wind load – Classification. - NF EN 12424 - 09-00
- Doors for industrial, commercial and garage premises – Resistance to water penetration – Classification. - NF EN 12425...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
