2. Direct torque control: DTC
Based on the same principles of flux and electromagnetic torque variation in asynchronous machines, direct torque control (DTC) was developed. As with DSC, the magnetic flux concerned is the stator flux, so as to avoid coordinate transformations. In this control, both flux and torque are regulated by hysteresis, so the number of commutations per stator period will be higher, as there will be not only commutations to regulate torque, but also those to regulate flux. As a result, this control is designed for lower power drives than the previous one. As before, an estimate of flux and torque is required.
2.1 Principle
Based on the estimated stator flux and electromagnetic torque, as performed in the DSC, flux and torque are subjected to hysteresis control, using...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Direct torque control: DTC
Conclusion
Article included in this offer
"Conversion of electrical energy"
(
278 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
References
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
