3. Control
As part of quality assurance, the entire chain is monitored:
RAW MATERIALS ;
molten metal ;
raw, processed and machined parts.
The inspection methods used by the manufacturer must enable the measured characteristic(s) to be determined with the precision required to guarantee compliance with the specifications of standard NF EN 1982 or other customer requirements accepted by the manufacturer.
In particular, equipment must be regularly calibrated, the frequency of calibration depending on the type of test.
3.1 Raw materials control
Today, the...
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
Control
Conclusion
Article included in this offer
"Metal forming and foundry"
(
124 articles
)
Updated and enriched with articles validated by our scientific committees
A set of exclusive tools to complement the resources
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
Already subscribed? Log in!
